7/9/2008
RS-603 REV A. 7
The WHITE/BLACK wire provides an instant shutdown for the remote start, whenever it is grounded. Connect the wire to
the hood pin switch previously installed. This wire must be routed though a grommet in the firewall and connected to the
hood pin switch.
Important! This connection is a safety wire and must be connected as shown and tested as specifiled. Failure to do so
may result in personal injury or property damage. See detail of wiring in the following diagram. This wire may also be used
if the vehicle brake light circuit switches ground to the brake lights. An isolation diode must be used for ground switched
brake light circuits and must be connected to the output of the brake switch.
To: White/Black
Negative safety
H3/4 BLACK/WHITE WIRE (-)Neutral Safety Switch Input
(-)Remote Start Enable Toggle Switch Input
When the BLACK/WHITE wire is grounded, the remote start unit is operable. When this wire is open from ground, the
remote start is disabled. This wire must be connected to the vehicles Neutral safety switch!
1. The optional “remote start toggle switch” can be added on to temporarily disable the Remote Start Device, it can prevent
the vehicle from being remote started accidentally. This feature is useful if the vehicle is being serviced or stored in an
enclosed area. To disable the remote start, move the optional remote start enable toggle switch to the OFF position. To
enable the remote start, move the optional remote start enable toggle switch to the ON position.
2. This wire MUST be connected to the PARK/NEUTRAL switch in the vehicle. (See the TESTING YOUR INSTALLATION
GUIDE)
IMPORTANT NOTE: Directly connect the BLACK/WHITE wire to the “GROUND” when this wire is not use d.
H3/5. WHITE/VIOLET WIRE : Positive safety shut down input
This wire provides an instant shutdown for the remote start, whenever it gets +12volts. If the brake lights switch in the
vehicle switches +12 volts to the brake light circuit, connect this wire to the output side of the brake switch. This will allow
the remote start to shut down if an attempt is made to operate the vehicle without the key while running under the control
of the remote start. In most vehicles, in order to shift gear, the brake pedal must be depressed. The brake input will in turn
cause the remote start unit to shut off. See below diagram.
+12 volts from fuse box
To White/ Violet wire
Brake light bulbs
Switch closes when
brake is depress
H3/6. GRAY WIRE : (-)200mA Chaneel #3 output -
This will become a 1 second pulse ground by activate channel 3 on transmitter for two seconds, the current capacity
of this wire is 200 mA. This feature allows you to remote control trunk release or other electric device.
H3/7. WHITE WIRE: (-) 200 mA Ground output while the engine is starting or running. This wire can be
used to activate a by-pass module and will provide a ground output when the engine is starting or
running from the remote starter.
H3/8 PINK WIRE : (-) 200ma PROGRAMMABLE OUTPUT (See Feature I - 2 Programming)
(21 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels